Goulds 1151AB2, Aquavar ABII, Constant Pressure Controller with Transducer, 1 HP

Description

Goulds Aquavar AB2 Variable Speed Controller
The Aquavar ABII pump controller provides an economical answer for municipal and private water systems with low water pressure. Both domestic and light commercial above ground boosters can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and up to 50% of the energy required by a full speed pump is saved. Think of it as "Cruise Control" for your pump.
Features
1 HP variable speed controller
Will work on single phase, 115V input power
Output power — Up to 230V three phase (based on input voltage). Motor rated for 208-230V, ±10%
Maximum output current — 4.2 amps
Transducer — 0.5 - 4.5 VDC with 5 VDC power supply, 100 psi range, 80-inch 3-core cable
Input Wire — 5 feet of 14 gauge cable. Cable is pre-wired to controller and junction box
Output Wire — 10 feet of 14 gauge cable
Up and down buttons to set pressure
Signal lights when power is on, pump is running, inverter stopped, pump stopped, standby, faults/errors
Over 95% electrical efficiency
Protection against short circuit, under voltage, overload, motor temperature, dead heading, run out, suction loss, sensor fault, bound pump, over voltage, static discharge
Maximum ambient temperature 104°F
Maximum humidity 95% at 104°F, non-condensing
Avoid mounting in areas with excessive dust, acids, corrosives and salts
NEMA 3R, IP 43 (rain-tight) enclosure
Wall mounted with convection air cooling
FCC compliant for interference
UL, CUL, CE approvals
Simple and quick installation
Applications
Low water pressure applications
Domestic and light commercial applications
Homes with multiple baths
Irrigation