Single Phase to 3 Phase Converter My PS 7 5 Model Suitable for 5HP

Description

Single Phase to 3 Phase Converter My PS 7 5 Model Suitable for 5HP
MY-PS-20, Best for 15Hp(11Kw) 45 Amp 200-240V Motor
MY-PS-20, Best for 15Hp(11Kw) 45 Amp 200-240V Motor
MY-PS-25, Best for 20Hp(15Kw) 60 Amp 200-240V Motor
MY-PS-10, Best for 7.5Hp(5.5Kw) 23 Amp 200-240V Motor
MY-PS-7.5, Best for 5HP(3.7Kw) 15 Amp 200-240V Motor
Model name
MY-PS-15
MY-PS-20
MY-PS-25
MY-PS-10
MY-PS-7.5
As you know, a wide variety of commercial and industrial electrical equipment require 3 phase power.
Most residential homes and small workshops are not been installed with 3 phase power by electric utilities, because it costs significantly more than single-phase installation.
Due to the unavailability and high-cost installation of 3 phase power network, a phase converter is very important to address this problem.
Thus, our DPS is a very good item for your 3 phase motor.
Excellent efficiency, more than other products.
Very low failure rate despite frequent operations.
Excellent start-up torque.
Small size & easy to install.
Semi-permanent lifetime.
Contactless type.
Due to the sealed type, very strong against dust, moisture, and heat.
Designed to be non-thermal.
Doesn't make any high frequency.
Could be used for 3 phase motor at your home or workshop.
MY-PS-10 model is best for 200V-240V 7.5HP(5.5KW, 23 amps) motor
1. MY-PS-7.5 model is best for a 5HP motor. (3.7KW, 15 amps)
2. It should only be used for one DPS per one motor. One DPS is not allowed to use on multiple motors.
3. The input/output voltage of our DPS is 200v~240v.
4. Our DPS is designed to be suitable for use in motor.
5. The efficiency is around 90~95%.
6. The voltage of the motor should be 200v~240v. If the voltage of your motor is 380v or 440v, you should change the wire of the motor to 200v~240v purpose to connect with an output of our DPS.
7. The thickness of the wires should be suitable for current(amps) and horsepower(HP).
8. Only a single-phase motor brake is allowed. (Three-phase motor brake is not working at our DPS)
9. You can measure 3 phases in the output of the DPS when your motor is running. So, normally, you could not measure voltages and amperes for V W legs if your motor is not running.
10. If your motor has a magnetic contactor or electronic switch, or brake, the control wires should be connected to U and W positions of the DPSs output.
Thus, if your motor is not running well or the motor is reversing, you should turn off the power immediately and you have to switch(swap) the wires on output(U, V, W) of our DPS. Actually, when you connect the wires from the output of the DPS to your motor, you could succeed the first time, or second time, or third time.
CAUTION
1. Our DPS could be made 3 phase when your motor is running. Please measure the voltages during running it.
2. Use DPS model suitable for motor horsepower(HP) and current(AMP). Otherwise, the motor may be damaged or not working.
3. The motor must be wired at 200V-240V.
You should select a model that meets the specifications for the motor.
Also, it should be used only for one DPS per one motor.